Epoxy Coal tar is known that solvent free Epoxy Coating. It is non porous have good chemical resistant.
Sea Water, Tap water de-ionized water Hydrochloric & Sulphuric Fumes, Dilute Acid
70°C to 80°C
Epoxy coal tar consisting of Epoxy Resin & Coal tar.
In order to obtain good working consistence the average mixing ratio as under:
The ratio will be slightly depending upon the temperature and working condition.
Concrete Surface The concrete/cement plastered surface shall be stable in construction free from cracks, pot holes, honey combs etc. The concrete should be cured as per for minimum of 28 days moisture free and the surface shall be dry, clean even in slightly rough, in line and level, maintaining required slope etc.,
The Surface must be clean & sound, remove all dirt, grease, curing compounds and other foreign matter by mechanical abrasion for acid etching. Remove water & dust from all surface prior to application.
Mild Steel Surface Mild steel surface are best prepared by sand blasting to remove all rust or scale. If sand blasting is not possible, power tool cleaning, wore brushing or abrading with coarse emery paper may be resorted to.
After proper mixing Epoxy Coal tar should be applied on clean & dry surface by wire brush.
Epoxy coal tar is a self hardening due to chemical reaction which occurs when the Epoxy Resin & Epoxy Coal tar are mixed together.
For Floor Application Cleaning the surface by wire brush & All Surface required dustless /Moisture .Apply One coat of Epoxy Coal Tar & spraying quartz sand over the epoxy coal tar.
For Tank Application Apply One coat of Epoxy Coal Tar Primer, Over Primed Surface To Applying 2-3mm Epoxy Screed Lining, Over Screed Surface To Apply Finish coat of Epoxy Coal Tar.
It is advisable to apply at least two coats to get an adequate film thickness.
Equipment & Hand should be cleaned before Epoxy Coal tar begins to set, soap and water is to be used for cleaning the purpose.
At the time of mixing or applying Epoxy Coal tar wear protection hand gloves, goggles and mask for protection.
All two components are stored in cool and dry place under the roof until ready to use it original unopened (Sealed) containers.